be

Search

You can find the results of your search below.

Matching pagenames:

Fulltext results:

Sump pump Monitor @projects:electronics
4 Hits, Last modified:
arents have a cistern and a sump pump which would be useful to have some sort of water level monitorin... d into the cistern, and the resulting level would be shown on the gauge. In order for the sump pump to be monitored accurately, the plastic hose from the pressure sensor must be slightly above where the water level when the pum
405nm Laser Diode
3 Hits, Last modified:
anslucent blue project box from Hammond that I'll be mounting the laser in. * 405nm (Blue) Laser ... df|Toshiba Laser Diode Product Catalog]] - Should be very useful - {{:projects:405nmlaser:bce0026_cata... nual]] - Not as useful as you might think. Should be useful for scavenging other parts off of the boar
Stirling Engine
3 Hits, Last modified:
gine ====== Raw materials purchased: * Brass tube - 19/32x0.014 * Brass tube - 9/16x0.014 * Brass rod - 3/32 * Brass tube - 1/8x0.014
Lenovo T530 Laptop WiFi upgrade
3 Hits, Last modified:
e system on a non-conductive surface (As you will be powering up a portion via the CH341A programmer. ... instructions on coreboot.org, I decided it would be safer to attempt this without removing the memory... 530s-screen.html I also highly recommend watching multiple YouTube videos on mating LVDS connectors.
C.H.I.P Computer
2 Hits, Last modified:
connection", configure your Wi-Fi - You should be able to SSH into CHIP now Hold down power button... are programmable via registers, so it appears to be possible to damage your CHIP computer by writing
Radio Communication
2 Hits, Last modified:
only for demonstration or trial does not have to be certified. However, it does require an experimental radio licence. More information can be obtained from the office of the Department neares
SD GPS Track Logger @projects:electronics
2 Hits, Last modified:
600|Still not working}} Still not working. Might be software or hardware, I'll need to check it on a ... _usb_demonstration_board_users_guide.pdf|}} Will be useful for future projects, however the included
CarouselPi - A Kodak Carousel Slide Scanner
1 Hits, Last modified:
n with a professional scanner. Loose slides will be scanned via the stackloader adapter. </WRAP> ===
Camera Flash Control
1 Hits, Last modified:
Flash Duration^^ |0.1ms delay|| |27 to 28ms|one tube| |13ms|two tubes| |11ms|three tubes| |8ms|Four tu
Gel Candles
1 Hits, Last modified:
/www.absolutcut.com/|Absolut Cut]] Bottles I will be using. Remember, drinking and glass cutting don't
Laser speckle display
1 Hits, Last modified:
==== Laser speckle display ==== Using a glass tube to suspend a skittle or piece of plastic and illum
7-segment display module @projects:electronics
1 Hits, Last modified:
r SMT resistor than the 0402 size. The board will be controlled via I2C from a PIC microcontroller, in
Magtek Card reader @projects:electronics
1 Hits, Last modified:
d|Vcc| |2|Black|GND| |3|Orange|DATA| |4|Brown|STROBE| |5|Green|CARD PRESENT| ==== Data Information ==
Tire Pressure Sensor @projects:electronics
1 Hits, Last modified:
then working out the math to something which can be easily done in assembly. {{:projects:electronics
Touch Sensor @projects:electronics
1 Hits, Last modified:
ensor ==== **Current Status: Prototype** {{youtube>large:LtHRDSMwfJU|Capacitance based light switch
OpenSCAD @projects:3d:openscad
1 Hits, Last modified: