pin

Search

You can find the results of your search below.

Fulltext results:

Magtek Card reader
4 Hits, Last modified:
ack 2 2.7 to 5.5VDC When no card is present all pins are high. When a card is present pin 5 goes low and remains that way for 140ms after the entire card has been read. ==== Pin Information ==== ^Pin ^Color ^Signal^ |1|Red|Vcc| |2|Black|GND| |3|Orange|DATA| |4|Brown|STROBE| |5|G
GPS
4 Hits, Last modified:
aicom HI-406BT ====== 19200bps, 8N1 Serial Data ^Pin^Wire^Description^ | |Blue|3V<sub>pk-pk</sub> seri... data I/O functions are integrated into a single 8-pin header 0787connector, J3. The J3 connector uses 0.150 inch (3.8 mm) pins on 0.0787 inch (2 mm) spacing ^Pin #^Function^Description^ |1|TXD 2|Port 2 transmit, CMOS/TTL| |2|Pr
Stepper motor driver
4 Hits, Last modified:
r:back_con.jpg?400|}} ^DB9^Connection^ |1|L298-Pin14-Output 4| |2|L298-Pin13-Output 3| |3|L298-Pin3-Output 2| |4|L298-Pin2-Output 1| |5|Ground?| |6|Logic?| |7|Logic?| |8|Logic?| |9|Logic?| ====== Ste
IO Board
3 Hits, Last modified:
ors, rated for 5 to 240 Volts, AC or DC. ====== Pinout ====== ^Relay board^Signal Name^Pin^#^Pin^Signal Name^ ||Gnd|Ground |B1 ^#|A1 |-I/O CH CK|I/O channel check; active low=parity error| |A3,
Temperature sensing devices
3 Hits, Last modified:
Accurate, 16-Bit Digital I2C Temperature Sensor ^Pin^^Wire Colour^ |1|SCL|Yellow| |2|SDA|Blue| |3|A0|G... |8|Vdd|Red| |7|Gnd|Black| Need 0.1uF Cap between pins 7 & 8 {{:projects:electronics:adt7410_pinout.png?600|}} From [[http://www.analog.com/en/sensors/d
Barometric Pressure sensor
2 Hits, Last modified:
ts:pic18f1320.pdf|PIC18F1320 Datasheet}} RX on pin 3 TX on pin 2 <code> Power ON 98.97 kPa, 742.3 Torr ; 0814,0521 98.97 kPa, 742.3 Torr
Panel Meter Interface
2 Hits, Last modified:
5K Ohm resistor @ 5V = 1mA ==== MCP4821 ==== ^Pin No.^Symbol^Function^ |1|Vdd|Supply (2.7 to 5.5V)|... ut BCF TRISC,SDA ; SCK as Output ;Set initial pin states BSF PORTB,RB1 ;Chip Select, active low
Serial Converter
2 Hits, Last modified:
MAX233CPP * Uses no external caps ===== Cable Pinout ===== ^Pin ^Wire Colour ^Description ^ |1 |N/C | |2 |Black |RD (Data to PC) | |3 |Brown |TD (Data f
MySensor board
1 Hits, Last modified:
breakout connectors for most of the remaining IO pins ^Qty^Device^Package^Parts^eBay search^ |1|ARDUI
Optical Mouse
1 Hits, Last modified:
the mouse as shown on the right. ^Color^Function^Pin^ |Red|Ground|Gnd| |Black|SCLK|RC3| |Orange|5V Pow
Optrex IM50240 Display
1 Hits, Last modified:
:projects:electronics:hd44100r_datasheet.pdf|}} ^Pin^Function^Notes^ |1|DL1|| |2|CL1|| |3|CL2|| |4|M|5
SD GPS Track Logger
1 Hits, Last modified:
ICtail Daughter Board Info Sheet}} ^Function^I/O^Pin^Description^ |SCK|O|RB1|SPI Clock Out| |SDI|I|RB0
X10 Interfacing
1 Hits, Last modified:
s (on three units I've used) so I figured out the pinout. 4N35's are used internally for opto-isolation