Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision | ||
projects:chip [2016/04/05 07:22] – created photonicsguy | projects:chip [2016/04/05 07:53] – photonicsguy | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ~~NOTOC~~ | ||
====== C.H.I.P Computer ====== | ====== C.H.I.P Computer ====== | ||
+ | ===== Headless Setup ===== | ||
+ | - Connect CHIP to your Linux computer via USB | ||
+ | - Run minicom -D / | ||
+ | - Login to chip, username: root, password: chip | ||
+ | - Run nmtui, a console based wireless configuration tool | ||
+ | - Select " | ||
+ | - You should be able to SSH into CHIP now | ||
+ | NOTE: The CHIP doesn' | ||
+ | |||
+ | Hold down power button for ~3 seconds to turn on, or ~10 seconds to turn off (hard power off, not a smooth shutdown) | ||
===== AXP209 ===== | ===== AXP209 ===== | ||
Line 60: | Line 71: | ||
Some of the voltage outputs are programmable via registers, so it appears to be possible to damage your CHIP computer by writing the wrong data to certain registers on this chip. | Some of the voltage outputs are programmable via registers, so it appears to be possible to damage your CHIP computer by writing the wrong data to certain registers on this chip. | ||
This script only uses one write command to enable ADC registers, everything else is only reading | This script only uses one write command to enable ADC registers, everything else is only reading | ||
+ | ==== Setting VBUS current limit ==== | ||
+ | * i2cset -y -f 0 0x34 0x30 0x60 # 900mA VBUS current limit (Default) | ||
+ | * i2cset -y -f 0 0x34 0x30 0x61 # 500mA VBUS current limit | ||
+ | * i2cset -y -f 0 0x34 0x30 0x62 # 100mA VBUS current limit (CHIP will draw from both VBUS & Battery) | ||
+ | * i2cset -y -f 0 0x34 0x30 0x63 # No current limiting on VBUS | ||
- | + | ===== References | |
- | ==== References ==== | + | |
* [[http:// | * [[http:// | ||
* [[http:// | * [[http:// | ||
* {{: | * {{: |