Search

You can find the results of your search below.

Lenovo T530 Laptop WiFi upgrade
9 Hits, Last modified:
ut how to modify the whitelist myself and to only use the forum as a last resort if I'm unable to make ... nkpad laptop (of course) * New wireless card, I used the [[http://www.intel.com/content/www/us/en/wir... from eBay or Aliexpress) * A second computer (I used another Linux computer. A Windows computer can w... c sheet - {{:projects:t530:magsheet.jpg?linkonly |useful for keeping screws in order}} * Hex driver f
Tire Pressure Sensor Code @projects:electronics:tirepressuresensor
5 Hits, Last modified:
wise, RA8 ; #define I2C_7SEG ; If Defined, use I2C to control display #DEFINE ADRC0 b'' #D... ll I2C_BusyWait endm #ifdef LCD_PICDEM ;The user can declare different definitions and make neces... instant an interrupt occurs. ; We don't use the "FAST" option for the Low Priority ISR ... ; Therefore, if only one ISR is required, use the High Priority ; with the FAST option
405nm Laser Diode
4 Hits, Last modified:
|Photodiode Anode | |8,9 |Laser Anode | ====== Useful Links ====== * [[http://repairfaq.cis.upenn.... ba Laser Diode Product Catalog]] - Should be very useful - {{:projects:405nmlaser:bce0026_catalog.pdf|L... A2_SVM.PDF|Toshiba HDA2 Service Manual]] - Not as useful as you might think. Should be useful for scavenging other parts off of the board, especially the di
C.H.I.P Computer
4 Hits, Last modified:
t to CHIP via a serial console - Login to chip, username: root, password: chip - Run **nmtui**, a c... VHOLD: 1 (Whether VBUS is above 4.4V before being used) Shutdown voltage: 2.9V VBUS current limit: 90... VHOLD: 1 (Whether VBUS is above 4.4V before being used) Shutdown voltage: 2.9V VBUS current limit: 10... certain registers on this chip. This script only uses one write command to enable ADC registers, every
Sump pump Monitor @projects:electronics
4 Hits, Last modified:
nts have a cistern and a sump pump which would be useful to have some sort of water level monitoring. ... - Measures up to 5 metres (200 inches) of water (Used for the cistern) * MPX5010 - Measures up to 1 metre (40 inches) of water (Used for the sump) * 2 Optically isolated inputs, o... red when the sump pump turns on, the other is not used * 1-wire network for temperature sensors * T
SD GPS Track Logger @projects:electronics
3 Hits, Last modified:
ics:sdgpslogger:picdem_fs_usb_demonstration_board_users_guide.pdf|}} Will be useful for future projects, however the included processor, the PIC18F4550 doe... gger/|GPS to SD-Card Data Logger]] - Does **not** use the FAT filesystem * [[http://www.k9spud.com/sd
My Electronic Projects
2 Hits, Last modified:
CB's * [[http://www.adafruit.com/|Adafruit]] - Useful components & dev boards * [[http://www.palt... s ====== Other Projects Online ====== [[http://users.tkk.fi/~jwagner/electr/rotary-enc/|Inexpensive
7-segment display module @projects:electronics
2 Hits, Last modified:
made this board using Eagle for layout and then I used [[http://www.batchpcb.com|BatchPCB]] to manufact... rrectly, however, if I were to revise it, I would use a larger SMT resistor than the 0402 size. The boa
IO Board @projects:electronics
2 Hits, Last modified:
round |B10^#|A10|I/O CH RDY|n/c| |B2 on U23 - not used|-SMEMW |B11^#|A11|AEN |Address enable; active high when DMA controls bus| |B1 on U23 - not used|-SMEMR |B12^#|A12|SA19 |n/c| |A3 on U23|-IOW |B1
X10 Interfacing @projects:electronics
2 Hits, Last modified:
ems to die after a few years (on three units I've used) so I figured out the pinout. 4N35's are used internally for opto-isolation, The power is from a tran
CarouselPi - A Kodak Carousel Slide Scanner
1 Hits, Last modified:
aloguing of the slide trays and indexing with the use of barcode stickers on each carousel. I intend to
Camera Flash Control
1 Hits, Last modified:
up a logic analyzer to the modulating signal * Use a microcontroller to try grounding the TTL OK sig
Data Logging
1 Hits, Last modified:
- Excellent graphing software written in Java, I use it as a frontend. ==== Perl Script ==== === In
Barometric Pressure sensor @projects:electronics
1 Hits, Last modified:
ide0024.htm ---- ===== Op-Amp Circuit ===== * Use an LM358 Op-Amp * 80 to 110 kilopascals >> 3.12
GPS @projects:electronics
1 Hits, Last modified:
8-pin header 0787connector, J3. The J3 connector uses 0.150 inch (3.8 mm) pins on 0.0787 inch (2 mm) s
Optical Mouse @projects:electronics
1 Hits, Last modified:
Serial Converter @projects:electronics
1 Hits, Last modified:
Tire Pressure Sensor @projects:electronics
1 Hits, Last modified: