using

Search

You can find the results of your search below.

Fulltext results:

Lenovo T530 Laptop WiFi upgrade
2 Hits, Last modified:
licyDxe_orig.sct LenovoWmaPolicyDxe_mod.sct - Using a hex editor, search for whitelist - Linux:... GPU if you have discrete graphics) - Note: I'm using a separate Bluetooth adaptor, so I'm not concerne
SD GPS Track Logger @projects:electronics
2 Hits, Last modified:
ector]] Need a PIC18 chip with more memory, I'm using the PIC18F4685 with 96Kbytes of program memory. ... e=en532040|AN1045 Implementing File I/O Functions Using Microchip?s Memory Disk Drive File System Library
Tire Pressure Sensor Code @projects:electronics:tirepressuresensor
2 Hits, Last modified:
;# ;# Program : Pressure sensor using an MPX5700DP sensor and LCD display ;# Versi... n) to allow ; usage of break-points when using the debugger. goto Start ; Go to t
405nm Laser Diode
1 Hits, Last modified:
ml]] ===== Collimating Lens ===== Currently I am using a plastic collimating lens intended for a red las
CarouselPi - A Kodak Carousel Slide Scanner
1 Hits, Last modified:
l slide projector into an automated slide scanner using a Raspberry Pi with a camera module. My main goal
C.H.I.P Computer
1 Hits, Last modified:
out: 4.5962 V </code> 100mA USB current limit (Causing the AXP209 to power the CHIP from both USB and th
Gel Candles
1 Hits, Last modified:
w.absolutcut.com/|Absolut Cut]] Bottles I will be using. Remember, drinking and glass cutting don't mix!
Michelson interferometer
1 Hits, Last modified:
I want to create a small Michelson interferometer using a laser diode and small, inexpensive mirrors. [[
Laser speckle display
1 Hits, Last modified:
==== Laser speckle display ==== Using a glass tube to suspend a skittle or piece of plastic and illumina
7-segment display module @projects:electronics
1 Hits, Last modified:
esided and surfacemount boards. I made this board using Eagle for layout and then I used [[http://www.bat
50 Amp 5 Volt Power Supply @projects:electronics
1 Hits, Last modified:
, 1% resistor to set the 5V output. Right now I'm using a 500 ohm potentiometer. 200 ohms would output 5.
DGPS-11 Beacon Receiver @projects:electronics
1 Hits, Last modified:
eacon Receiver module mounted in a weatherproof housing. ^ Wire ^ Function ^ | Red|+3A fused 10.8 to 31.
MySensor board @projects:electronics
1 Hits, Last modified:
LL"></HTML> ===== Components and layout ===== I'm using prebuilt modules for the Arduino mini pro and the
Tire Pressure Sensor @projects:electronics
1 Hits, Last modified:
culations.pdf|calculations}} I did for the module using a spreadsheet to graph the transfer function, the