use

Search

You can find the results of your search below.

Matching pagenames:

Fulltext results:

Tire Pressure Sensor Code @projects:electronics:tirepressuresensor
5 Hits, Last modified:
wise, RA8 ; #define I2C_7SEG ; If Defined, use I2C to control display #DEFINE ADRC0 b'' #D... ll I2C_BusyWait endm #ifdef LCD_PICDEM ;The user can declare different definitions and make neces... instant an interrupt occurs. ; We don't use the "FAST" option for the Low Priority ISR ... ; Therefore, if only one ISR is required, use the High Priority ; with the FAST option
Sump pump Monitor
4 Hits, Last modified:
nts have a cistern and a sump pump which would be useful to have some sort of water level monitoring. ... - Measures up to 5 metres (200 inches) of water (Used for the cistern) * MPX5010 - Measures up to 1 metre (40 inches) of water (Used for the sump) * 2 Optically isolated inputs, o... red when the sump pump turns on, the other is not used * 1-wire network for temperature sensors * T
SD GPS Track Logger
3 Hits, Last modified:
ics:sdgpslogger:picdem_fs_usb_demonstration_board_users_guide.pdf|}} Will be useful for future projects, however the included processor, the PIC18F4550 doe... gger/|GPS to SD-Card Data Logger]] - Does **not** use the FAT filesystem * [[http://www.k9spud.com/sd
7-segment display module
2 Hits, Last modified:
made this board using Eagle for layout and then I used [[http://www.batchpcb.com|BatchPCB]] to manufact... rrectly, however, if I were to revise it, I would use a larger SMT resistor than the 0402 size. The boa
IO Board
2 Hits, Last modified:
round |B10^#|A10|I/O CH RDY|n/c| |B2 on U23 - not used|-SMEMW |B11^#|A11|AEN |Address enable; active high when DMA controls bus| |B1 on U23 - not used|-SMEMR |B12^#|A12|SA19 |n/c| |A3 on U23|-IOW |B1
X10 Interfacing
2 Hits, Last modified:
ems to die after a few years (on three units I've used) so I figured out the pinout. 4N35's are used internally for opto-isolation, The power is from a tran
Barometric Pressure sensor
1 Hits, Last modified:
ide0024.htm ---- ===== Op-Amp Circuit ===== * Use an LM358 Op-Amp * 80 to 110 kilopascals >> 3.12
GPS
1 Hits, Last modified:
8-pin header 0787connector, J3. The J3 connector uses 0.150 inch (3.8 mm) pins on 0.0787 inch (2 mm) s
Optical Mouse
1 Hits, Last modified:
calmouse.jpg?400|}} With this project I intend to use an optical mouse sensor chip for detecting moveme
Serial Converter
1 Hits, Last modified:
====== Serial Converter ====== MAX233CPP * Uses no external caps ===== Cable Pinout ===== ^Pin ^Wir
Tire Pressure Sensor
1 Hits, Last modified:
tead of the LCD display the finished project will use the [[7segdisplay]] to make it easier to read und